| |
(Instructions provided by Prometheus International, Inc.)
BUTANE LIGHTER REFILLING INSTRUCTIONS:
CAUTION: Do not refill close to an open flame!
| Figure 1. | | to
fill
gas |  | to
adjust
flame |
- Extinguish the flame of your butane lighter.
- Turn the flame height adjuster on the bottom of the butane lighter to the
lowest setting by turning the adjuster clockwise with a small screwdriver.
- Take air out of the fuel tank by pressing the refill inlet valve with a small
screwdriver until no hissing sound is heard. Hold butane lighter away from face
when taking air out. Air in the fuel tank deters butane gas from being injected
into the tank and elicits the malfunction of the butane lighter. If butane gas
comes out of the inlet valve when the inlet valve is pressed, stop bleeding the
fuel tank immediately. In this case, the fuel tank is filled with butane gas.
- Refill butane lighter in an upside down position as shown above.
- After shaking the butane gas refill can, press the stem of the refill can
directly onto the refill inlet valve on the bottom of the butane lighter and let
butane gas go into the lighter for about 10 seconds.
- Do not ignite butane lighter for about 2 - 5 minutes until the butane gas in the gas tank reaches room temperature.
- Open the flame height adjuster by a quarter turn at a time by turning
counter-clockwise until the flame height reaches the desired level. Hold butane
lighter away from face when igniting. If the flame height adjuster is turned up
too high, the lighter will not ignite and you will hear a hissing sound. If this
happens, please lower the adjuster by turning clockwise.
- If the fuel tank is empty, refill rather than adjusting flame height.
| |
